#Staples.com flash drive for windows 98 installI’m not sure that this is even possible as 98 relies on the Install Media to be active through the Install Process and 98 didn’t have any USB Support till the SE Version and even then it wasn’t very good so I don’t know if this will even work here. If it doesn’t either you have the Install Disc copied incorrectly or the Tablet doesn’t support Booting off a USB Device. It should then find the Install Files on the USB Drive and ask do you want to install from there. Save these changes on exit and allow the system to restart. When you have the entire Install Disc of 98SE copied to the USB Stick all that should be required if your hardware supports this option is to insert the USB Stick into a USB Port and boot the Tablet then enter BIOS and select the First Boot Device as the USB then the HDD as the second Boot Device. #Staples.com flash drive for windows 98 driversHint! You may as well copy the Motherboard Device Drivers to the USB Stick at the same time as you are going to need them, also copy your Antivirus Sofware that you are going to install When you get back to the DOS Prompt type in CD Win9X and press Enter. Once that is complete recreate the Primary Partition, exit out and restart the PC. Now you will have to remove the Non DOS Partition, delete the NON DOS Logical Partition first and then the NON DOS Active Partition. Turn on the PC and you should end up with a DOS Prompt. When you have finished doing that, disconnect the USB Stick and insert it back into the original PC. Restart the PC and reconnect the USB Stick, now you will need to copy the Win9X Folder from your XP CD to the USB Stick. When you have finished installing DOS shutdown the PC and reconnect the Hard Drive. Insert the DOS CD that you created and follow the prompts to install it to the USB Drive. Connect your USB Stick and turn on the PC. If you have access to the necessesary equipment keep the Active Partition at 2GB Read On.ĭownload the MS-DOS 7.10 Installation CD ISO Imageīurn it to CD using Nero or any other Software that will support the ISO Image.Įnsure that you have an Active Partition on the new Drive and it is Formatted FAT32ĭisconnect the Hard Drive from the PC that you have been using. Sample and an alternative way: Read the documentation below.īecause a lot of newer PC’s don’t have Floppy Drives anymore I use Virtual Floppy Drive. Tip.ĝont forget to modify Autoexec.bat and Config.sys so that they don’t reflect any Drives. You will need a DOS Boot Disk which can be downloaded from below.ĭownload these files and add the new fdisk.exe to the floppy when it is created. If you haven’t already Partitioned and made the USB Stick Active you may need to create a Bootable CD with Fdisk.exe on it to prepare the USB Stick if you haven’t a Floppy Drive.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |